2006-2009 Yamaha YFM700RV Raptor 700RV factory service manual, Page 75Get this manual
CABLE ROUTING Secure the plastic band by inserting the projection on the band into the hole in the frame Fasten the wire harness with the plastic band so that the ECU lead is routed downward Route the starter motor lead between the frame and the battery box, then under the crankcase breather hose Make sure that there is not excessive slack in the wire sub lead in the area shown in the illustration
Route the wire sub lead as shown in the illustrationThe longer lead past the end of the protective sleeve is the neutral switch lead and the shorter lead is the reverse switch lead Route the A.Cmagneto lead, negative battery lead, wire sub lead, rear brake light switch lead, and speed sensor lead between the crankcase breather hose and the starter motor lead, and to the rear of the leads that branch off from the wire harness