2006-2009 Yamaha YFM700RV Raptor 700RV factory service manual, Page 73Get this manual
CABLE ROUTING Route the leads that branch off from the wire harness over the crankcase breather hose, then towards the right side of the vehicle, making sure that they do not contact the frame Route the lean angle sensor lead to the outside of the A.Cmagneto lead, negative battery lead, wire sub lead, rear brake light switch lead, and speed sensor lead Connect the negative battery lead to the negative battery terminal
Secure the plastic band by inserting the projection on the band into the hole in the frame, and then fasten the wire harness at the center of its positioning tape with the band, making sure that the end of the band faces rearward and the leads that branch off from the wire harness do not contact the frame Make sure that there is no slack in the wire harness in the area shown in the illustration