2004-2007 Yamaha ATV Raptor 50 YMF50S Service Manual, Page 175Get this manual
REAR AXLEFINAL DRIVE ASSEMBLY AND DRIVE SHAFT EBS00397
INSTALLING THE NUTS 1Tighten: nuts 1, 2
MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM
aCheck if the rear brake assembly is installed on the rear axle housingIf the rear brake assembly is not installed, refer to "FRONT AND REAR BRAKES" in chapter for installation instructionsNOTE: Before tightening the nuts, apply the LOCTITE to the thread portion of the rear axlebFinger tighten the inside nut while checking the ring gear engagementcTighten the inside nut with rear axle nut wrench to specification while holding the rear axleAxle nut wrench (36 mm) PNYM-37132, 90890-01422 Inside nut (first tightening) 110 Nm (11.0 kg, 80 ft lb)