2004-2005 660 Yamaha Rhino Factory Service Manual, Page 283Get this manual

2004-2005 660 Yamaha Rhino Factory Service Manual, Page 283

REAR CONSTANT VELOCITY JOINTS, FINAL DRIVE GEAR AND DRIVE SHAFT

Adjusting the final gear lash 1Remove: ring gear bearing housing ring gear shim(s) ring gear thrust washer 2Adjust: gear lash
MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM

aSelect suitable shim(s) and washer(s) using the following chartToo little gear lash Too large gear lash

Back to 2004-2005 660 Yamaha Rhino Factory Service Manual