2003 Yamaha YFM400FAR Kodiak Factory Service Manual, Page 307Get this manual
REAR SHOCK ABSORBER AND SWINGARM
INSTALLING THE REAR AXLE HOUSING 1.Install: Rear axle housing Final gear case assembly Rear axle (with dust seal) Installation steps: Install the drive shaftRefer to "REAR AXLEFINAL DRIVE GEAR AND DRIVE SHAFT" in CHAPTER 7G Apply sealant (Quick Gasket) to the mating surfaces of the swingarm and the final gear caseG Temporarily install the rear axle housing and final gear case assembly on the swingarmThe bolts and nutsshould be temporarily tightenedG Install the rear axle (with dust seal) from the left side of the machineRefer to "REAR AXLEFINAL DRIVE GEAR AND DRIVE SHAFT" in CHAPTER 7G Tighten the bolts and nutsin the specified order3 Nut (4) Bolt (4) Boltnut (4)