1998-2001 Yamaha YFM600FHM Grizzly Factory Service Manual, Page 241Get this manual
CONSTANT VELOCITY JOINTS AND DIFFERENTIAL GEAR
CONSTANT VELOCITY JOINT ASSEMBLY 1.Apply: Molybdenum disulfide grease (into the ball joint assembly)
NOTE: _ Molybdenum disulfide grease is included in the repair kit
2.lnstall: Dust boots D Boot bands
Installation steps:
The new boot bands may differ from the original ones The dust boots should be fastened with the boot bands at the grooves in the joint shaft Apply molybdenum disulfide grease into the dust boots
Molybdenum disulfide grease: 70 (2.5 oz) per dust boot
Install the dust boots D Wrap the boot bands around the dust boots twice, then pass the band ends through the loops Tighten the boot bands by pulling the boot band ends with pliers until the boot band outside diameters meet specificationBoot band