1987-2009 Yamaha ATV YFM350X Warrior Raptor Service Manual, Page 370Get this manual
CABLE ROUTING Route the drive select lever switch lead on the outside of the drive select lever bracket, and then under the ground lead Fasten the throttle cable and drive select lever switch lead with plastic clamp Route the main switch lead over the headlight bracket Pass the headlight lead between the headlight bracket and the headlight Route the starter motor lead in front of the front fender bracket
Pass the starter motor lead through the guide Fasten the rear brake light switch lead under the frame with two plastic bandsFace the end of each band rearward Pass plastic band through the holes in the fuel tank shield, and then fasten the throttle cable and drive select lever switch connector with the plastic bandThe end of the plastic band should be under the frame, facing inward