2008 Suzuki LT-A400/F, LT-F400/F ATV Service Manual, Page 431Get this manual
Manual Transmission: Fit the special tool and install the 2nd drive gear using hydraulic pressSpecial tool (A): 0991370210 (Bearing installer set) Assembly When assembling the reverse gearshift cam, pay attention to the following points:! 5B-6
CAUTION
I827H1520013-01
Never reuse snap ringAfter snap ring has been removed from shaft, it should be discarded and new snap ring must be installed When installing snap ring, care must be taken not to expand the end gap larger than required to slip the snap ring over the shaft After installing snap ring, always ensure that it is completely seated in its groove and securely fitted Align the punch mark "A" with "B" on the shaft