2008 Suzuki LT-A400/F, LT-F400/F ATV Service Manual, Page 328Get this manual
3C-17 Transfer: Installation Install the gear position switch in the reverse order of removalPay attention to the following points: Apply bond lightly to the gear position switch lead wire grommet (1): Sealant 9900031140 (SUZUKI BOND No.1207B or equivalent) 3) Remove the gearshift shaft assembly (2)I827H1330050-01
I827H1330035-03
Route the gear position switch lead wireRefer to "Wiring Harness Routing Diagram in Section 9A (Page 9A-8)" Install the V-belt inner coverRefer to "Clutch Shoe Removal and Installation in Section 5A (Page 5A-16)" Install the drive V-beltRefer to "V-belt Type Continuously Variable Automatic Transmission Removal and Installation in Section 5A (Page 5A-7)"
4) Remove the following parts from the gearshift shaft (3) Spacer (4) Transfer shift gear (5) Return spring (6) Snap ring (7) Washer (8) Special tool0990006107 (Snap ring pliers)