2008 Suzuki LT-A400/F, LT-F400/F ATV Service Manual, Page 265Get this manual
Drive ChainDrive TrainDrive Shaft:
Front Drive Shaft Assembly Removal and Installation (LT-A400F, LT-F400F)
CAUTION
Removal 1) Drain the front differential gear oilRefer to "Front Differential Gear Oil Inspection (LT-A400F, LTF400F) in Section 0B (Page 0B-9)"2) Remove the steering knuckleRefer to "Front Wheel HubSteering Knuckle Removal and Installation in Section 2B (Page 2B-3)"3) Hold the inboard joint (1) of the front drive shaft and tug the drive shaft horizontallyNOTE If it is difficult to remove the front drive shaft from the front differential gear case, use the suitable tool
B827H23106002
Be careful not to damage the front differential gear case oil sealsNOTE After installing the drive shaft, make sure the circlip is seated properly by pulling inboard joint lightly
I827H1310002-05
I827H1310001-01
Install the steering knuckleRefer to "Front Wheel HubSteering Knuckle Removal and Installation in Section 2B (Page 2B-3)" Install the front wheelRefer to "FrontRear Wheel Removal and Installation in Section 2D (Page 2D-3)" Pour the front differential gear oilRefer to "Front Differential Gear Oil Inspection (LT-A400F, LT-F400F) in Section 0B (Page 0B-9)"