2008 Suzuki LT-A400/F, LT-F400/F ATV Service Manual, Page 204Get this manual
1I-7 Starting System: 3) Remove the neutral relay (1)2) Disconnect the neutral switch diode (1)[A] [B]
I827H1190012-01
I827H1190013-02
Installation Install the neutral relay in the reverse order of removal
[A] LT-A400F
[B] LT-F400F
Neutral Relay Inspection
Inspect the neutral relay in the following procedures: 1) Remove the neutral relayRefer to "Neutral Relay Removal and Installation (Page 1I-6)"2) Check the insulation between "A" and "B" terminals using the multi-circuit tester3) Apply 12 to terminals "C" and "D" ((+) to "C" and) to "D") and check the continuity between "A" and "B"If there is no continuity, replace the neutral relay with new oneSpecial tool0990025008 (Multi-circuit tester set) Tester knob indication Continuity test)
B827H21906008
3) Measure the voltage between the "A" and "B" terminals using the multi-circuit testerIf any abnormality is found, replace the diode with new oneSpecial tool0990025008 (Multi-circuit tester set) Tester knob indication Diode test)