1987-2006 Suzuki ATV LT80 Service Manual, Page 106Get this manual
ELECTRI CAL SYSTEM
Hold the electrolyte container with its nOzzles upright, and use wire cutters, etcto cut out off the end of he no zz les at the designated locations (between the ends and the packing)
Insert the no zzles of the electrolyte container into the battery's electrolyte filter holes, holding the container firmly so that it does not fallTake precaution not to altow any of the fl uid to spill Use wi re cutters to cut the protruding part on the bottom of each container, and leave in this position for about 10 minutes
Position for opening holes
Insen in filler
After confirming that the electrolyte has entered the battery completelyremove the electrolyte containers from the batteryWait for around 10 min utes Insert the stoppers into the filler holes, pressing in firml so that the top of he stoppers do not protrude above the upper surface of the battery's top coverCAUTIONNever use anything except he specified battery Once insta ll the stoppers to the battery, do not remove the stoppers Using Suz uki pocket tester, measure the battery voltageThe tester should indicate more han 12.5 (DC) as shown in the FigIf the battery vol tage is lower than the specification, charge the battery with battery charger(Refer to he recharging peration on page 5- 10 NOTEInitial charging for new battery is recommended if two years have elapsed since tha date of manufactura