2012 Sportsman 400/500 and EFI Tractor Service Manual 9923412, Page 40Get this manual
MAINTENANCE Engine Oil Level Oil and Filter Change Oil Filter Torque: Turn by hand until filter gasket contacts sealing surface, then turn an additional 12 turn Oil Filter Wrench: (PV-43527) Oil Tank Screen Fitting Torque: 25 ft-lb (34Nm) Recommended Engine Oil: A
The oil tank is located on the left side of the vehicleTo check the oil level: 1Set machine on level surface2Clean the area around the dip stick3Start and run engine for 20-30 secondsThis will return oil to its true level in the oil tank4Stop engine, remove dipstick (A) and wipe dry with clean cloth5Reinstall dipstick, screw the dipstick into placeNOTE: The dipstick must be screwed completely in to ensure accurate measurementADD OZNORMAL FULL
Polaris PS PLUS Synthetic, 2W-5o WARNING
Personal injury can occur when handling used oilHot oil can cause burns or skin damageNOTICE: Care must be taken to ensure that the fluids are containedBe prepared to collect the fluid with suitable containers before opening any compartment or disassembly of any component containing fluids1Place vehicle on level surface2Clean area around drain plug (A) at bottom of oil tank3Run engine two to three minutes until the engine is warm4After two or three minutes stop the engine5Place drain pan beneath oil tank and remove the drain plug (A)CAUTION: Oil may be hotDo not allow hot oil to come into contact with skin as serious burns may result