2011 Polaris Ranger RZR ATV Service Manual, Page 284Get this manual
FINAL DRIVE 4Lift bearing carrier into place and install the bolt attaching the bearing carrier to the upper A-armTorque fastener to specification
Rear Caliper Mounting Bolts: 18 ftlbs(24 Nm)
New bolts have pre-applied locking agent which is destroyed upon removalAlways use new brake caliper mounting bolts upon assembly8Torque wheel hub nut to 80 ftlbs(108 Nm) and install NEW cotter pinTighten nut slightly if necessary to align cotter pin holes
Upper Rear Bearing Carrier Bolt: RZR: 33 ftlbs(45 Nm) RZRRZR 4: 40 ftlbs(54 Nm) 56Apply grease to drive shaft axle splinesInstall rear wheel hub assembly, cone washers, and hand tighten the castle nutInstall washers with domed side out