2011 Polaris Ranger RZR ATV Service Manual, Page 240Get this manual
CLUTCHING NOTE: Use Bushing Tool PA-47336
Clutch components will be hot! In order to avoid serious burns, wear insulated gloves during the removal processInstall nut (C) onto end of puller rod and hand tightenTurn puller barrel to increase tension on sheave if neededUsing hand held propane torch, apply heat around outside of bushing until tiny smoke tailings appearTurn sheave counterclockwise on puller rod until it comes freeLift sheave off puller
9Moveable SheaveBushing Removal 12Remove clutch as outlined previously in this chapterInstall handle end of the Piston Pin Puller (PN 2870386) securely into bench vise and lightly grease puller threads
10Remove nut from puller rod and set aside11Pull bushing removal tool and adapter from puller rodRemove bushing from tool and discardDrive Clutch Bushing Installation 1Place main adapter (Item 8) on pullerPuller Tool (A,B) Side "A" toward sheave Nut (C)
Piston Pin Puller (PN 2870386)
3Remove nut from puller rod and set aside
Piston Pin Puller (PN 2870386)
Main Puller Adaptor (#8) (PN 5020632)