2011 Polaris Ranger RZR ATV Service Manual, Page 232Get this manual
CLUTCHING DRIVE BELT
Belt Removal
12Remove outer clutch cover as described in the "PVT Disassembly" sectionMark the drive belt direction of rotation so that it can be installed in the same direction3Belts with thin spots, burn marks, etc should be replaced to eliminate noise, vibration, or erratic PVT operationSee the Troubleshooting Chart at the end of this chapter for possible causes
Belt Installation
NOTE: Be sure to position belt in the same position as when removed or so part number is easily read1Loop belt over the drive clutch and over top of the driven sheave
NOTE: Belt is normally positioned so that the part number can be easily read3To remove drive belt, place the transmission in "Park" and push down on the belt firmly to open the clutch sheaves