2011 Polaris Ranger RZR ATV Service Manual, Page 231Get this manual
CLUTCHING 4Reinstall the driven clutch and drive beltTorque the driven clutch retaining bolt to 17 ftlbs(23.5 Nm)Be sure to rotate the driven clutch counterclockwise several times to ensure the belt is tight and riding at the proper height in the clutchProper Height 89Install the outer clutch cover and torque the cover screws to 45-50 inlbs(5-5.6 Nm)Install the clutch cover outlet duct and tighten the clamps
10Sit in the driver's seat, apply the brake and start the enginePlace the gear selector in high range and test the vehicle for drive clutch drag or hard shifting while at idle speedIf shifting remains difficult, refer to the note belowNOTE: If the vehicle or drive clutch is new (less than 0.2 hours), remain in the driver's seat with the gear selector in high rangeAllow the engine to idle for five minutes to break in the drive clutch hub bearing