2011 Polaris Ranger RZR ATV Service Manual, Page 229Get this manual
CLUTCHING 10Install the Drive Clutch Holder (PN 9314177) (A)11Remove drive clutch retaining bolt and remove drive clutch using the Drive Clutch Puller (PA-48595) (B)
PVT Assembly
123Inspect inner clutch coverReplace if cracked or damagedInspect the seal on the transmission input shaftReplace if damagedApply RTV silicone sealant to the back side of the inner clutch cover to ensure water tight fit between the engine and inner clutch coverBoth surfaces must be clean to ensure adhesion of silicone sealant
Drive Clutch PullerPA-48595) Drive Clutch Holder (9314177)
12Remove the (3) screws and (3) bolts that retain the inner clutch cover to the engine and transmission456Install and properly align the inner clutch coverInstall the bolts and washers that retain the cover to the transmissionTorque bolts to specification (see next page)Install the screws that retain the cover to the engineTorque screws to specification (see next page)Remove any excess silicone sealantInstall clutch offset washers on the transmission input shaftOffset Washers