2011 Polaris Ranger RZR ATV Service Manual, Page 219Get this manual
BODYSTEERINGSUSPENSION 16Using 916" socket wextension, remove the fastener retaining the clicker valve stackPlace the valve stack on clean shop towel in order of removal4Place new lock nut onto the shock rodTorque the new lock nut to specification
IMPORTANT: Do not over torque the nut or damage to the valve stack can occur
Remove Lock Nut Torque: 14 ftlbs(19 Nm) NOTE: Make sure "Top-Out" washers are orientated as shownClicker valve stack Top-Out Washers
IMPORTANT: Keep the valve stack in the order it was removedIf unsure of order, refer to "Shock Valving" under the "Shock Service Information" provided earlier in this section17Inspect the valves for kinks, waves, pits or foreign material 18Thoroughly clean all shock components and shock body prior to assemblyNOTE: Actual valve stack may differ from what is shown here