2011 Polaris Ranger RZR ATV Service Manual, Page 143Get this manual
ELECTRONIC FUEL INJECTION Verify TPS Tester Reference Voltage volt reference voltage from the TPS Tester harness is required for the TPS test to be accurateRefer to the instructions provided with the TPS Tester (2201519-A) or follow the bullet point steps below to check reference voltageReference Voltage Test: Insert black voltmeter probe in the test port as shownto Insert red voltmeter probe into the test port as shown and verify the voltage reads 4.99-5.01 VdcIf the reading is low, replace the volt battery23
TPS Replacement
NOTE: The correct position of the TPS angle on the throttle body is established and set at the factoryIf the TPS is replaced or has been loosened it must be repositioned to obtain the proper voltage reading1Remove the seats, rear service panel and the rear cargo box (see Chapter 5)Loosen the hose clamps retaining the throttle bodyRemove the throttle body from the intake track and plug the intake boots with clean shop towel