2011 Polaris Ranger RZR ATV Service Manual, Page 124Get this manual
ELECTRONIC FUEL INJECTION 7Install the sensor by inserting it with twisting motion to properly seat the grommetTorque to Specification
The two-tooth gap creates an "interrupt" input signal, corresponding to specific crankshaft positionThis signal serves as reference for the control of ignition timing by the ECUSynchronization of the CPS and crankshaft position takes place during the first two revolutions each time the engine is startedThis sensor must be properly connected at all timesIf the sensor fails or becomes disconnected for any reason, the engine will stop running
CPS Test
Intake Boot The CPS is sealed, non-serviceable assemblyIf fault code diagnosis indicates problem with this sensor, test as follows: 1Disconnect CPS (3-wire) harness connector on the lefthand side of the vehicle located below the transmissionInstall the retaining bolt and torque to specification
T-MAP Retaining Bolt Torque: 25 2.5 inlbs(3 .3 Nm)