2011 Polaris Ranger RZR ATV Service Manual, Page 115Get this manual
ELECTRONIC FUEL INJECTION TPS Tester Regulator547927 This tester regulator is part of 2201519-AIt regulates the volt battery voltage to volt reference input, required when using the TPS Tester Wire Harness (PU-47466)Fuel Pressure Gauge AdaptorPV-48656
Adaptor works with PU-43506-A
Disconnect here and connect in-line wfuel pump outlet
NOTE: You may already have this regulator (marked 4010264) as part of another TPS Tester KitIf you do not have this regulator, you must order one from SPX at 1-800-328-6657Fuel Pressure Gauge KitPU-43506-A IMPORTANT: The EFI fuel system remains under high pressure, even when the engine is not runningBefore attempting to service any part of the fuel system, pressure must be relieved (if applicable)The Fuel Pressure Gauge Kit has an integrated pressure relief valve that can be used to bleed off pressure once you have completed the fuel pressure testDigital WrenchTM Diagnostic SoftwarePU-47063-A This dealer-only software installs on laptop computers equipped with CD drive and serial port connection, and is designed to replace multiple shop tools often used to test EFI componentsIt also includes step-by-step diagnostic procedures to aid technician repair and troubleshootingIMPORTANT: If the PC you are using is not equipped with 9-pin serial port, USB to serial port adaptor will be necessaryA USB to serial port adaptor can be purchased through DSA at: Digital WrenchTM SmartLink Module KitPU-47471 This module kit contains the necessary cables and hardware to communicate between the vehicle ECU and the Digital WrenchTM diagnostic softwarePolaris dealers can also order the following kit components separately: SmartLink Module PU-47468, Vehicle Interface Cable PU-47469 and PC Interface Cable PU-47470This module kit is used on all pin connector-based Polaris EFI systemsThis kit is available to Polaris dealers through our tool supplier SPX at (1-800-3286657) or http:polaris.spx.com