2011 Polaris Ranger RZR ATV Service Manual, Page 92Get this manual
ENGINE 19Once the gears are pressed together, firmly hold the gears together with one handCarefully remove the Tapered Pins (PU-45497-1) by pulling them out one at time with the other hand21To remove the balance shaft gear, the flat side of the camshaft (P) must face the balance shaft gearTo rotate the camshaft, use the Cam Spanner Wrench (PU-45498) to rotate the camshaft so the flat side of the camshaft faces the balance shaft gear
PU-45498
20After the tapered pins are removed, be sure the cam gear assembly is held together tightlyPlace the cam gear assembly on flat surfaceUse the Cam Gear Tooth Alignment Tool (PU-45497-2) to align the teeth of the cam gears, as shown in the pictureNOTE: Install the Cam Gear Alignment Tool (PU45497-2) into one assembly hole counter clockwise from the timing mark