2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 246Get this manual
ELECTRICAL
HEADLIGHT ADJUSTMENT
The headlight beam can be adjusted up and down1Place the vehicle on level surface with the headlight approximately 25' (7.6 m) from wall2Measure the distance from the floor to the center of the headlight and make mark on the wall at the same height3Start the engine and turn the headlight switch on the High Beam setting4Observe headlight aimThe most intense part of the headlight beam should be aimed (5.1 cm) below the mark placed on the wall in step 2NOTE: Rider weight must be included on the seat25' (7.6 m) Lamp Center Height 2Gently pull back locking tabs on wire harness terminal until base of bulb is releasedUnplug bulb from harness3Plug new bulb into wire harness, making sure it snaps into place4Carefully insert bulb into back of housingTurn 90 to lock into placeThe harness connector should be pointing down