2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 231Get this manual
ELECTRICAL
CRANKING OUTPUT TEST WITH PEAK READING VOLTMETER
The following peak voltage tests will measure the amount of output directly from each componentA peak reading voltmeter should be used to perform the CDI output testA variety of peak reading adaptors are commercially available for use with the Fluke 77 Digital Multimeter (PV-43568) and other digital VOMs which will allow peak voltage tests to be performed accuratelyFollow the directions provided with the adaptorAll measurements are indicated in DC VoltsReadings obtained without peak reading adaptor will be significantly differentThe starter system must be in good condition, engine undamaged and the battery fully charged
LIMITER SPECIFICATIONS
Speed Limiter Module LR ID Number
Part number is printed on module NOTE:The part number is printed on some late model LR modulesWhenever possible, use that part number to identify the moduleModules may have same "LR" I.Dnumber, but may have different part numbers, terminals, and internal functionsLIMITER SPECIFICATIONS Refer to parts manual or microfiche for part number and applicationFUNCTIONLIMIT RPM Reverse Limit3100 COMMENTS Scrambler 500