2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 175Get this manual
FINAL DRIVE 3Install snap ring to contain bearing cap just installedRepeat procedure for other side3Elevate and support machine under footrestframe areaCAUTION: Serious injury may result if machine tips or fallsBe sure machine is secure before beginning this service procedureWear eye protection when removing and installing bearings and seals4Remove right wheel nuts and wheel
4Install outer yoke, aligning marks made before disassembly5Repeat Steps 1-3 to install bearing caps on outer yoke5Remove cotter pin, lower ball joint nut and A-arm from ball joint6Punch spring pins out from both axle splines and front prop shaft7Remove bolts securing bottom of housing to frameRemove vent lineRemove housing from right side of frame