2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 169Get this manual
FINAL DRIVE 2Remove cotter pin and castle nut from A-arm ball joint3Disconnect A-arm from ball joint using tie rod fork5Remove clamps from rubber boot using the proper boot clamp pliersRetaining ring
Pull shaft to remove from CV joint 6Remove the large end of the boot from the CV joint, slide the boot back and separate the wheel spindle and CV joint assembly from the axle shaft by pulling the shaft sharply outward, away from the CV jointIt may be necessary to tap the CV joint assembly outward with soft faced hammer7Remove small clamp and boot from driveshaftIf the ATV has been operated with damaged boot, the CV joint grease may be contaminatedInspect the grease carefully for contamination, and clean the joint thoroughly if necessaryFront drive axle CV boot replacement requires 30g of greaseIf CV joint is cleaned, an additional 30g of grease is requiredRefer to information below8Before installing the new boot, remove all grease from the boot area and shaftNOTE: It is very important to use the correct type and quantity of grease by using the grease contained in