2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 168Get this manual
FINAL DRIVE 10Using Roll Pin Remover (PN 2872608), remove the roll pin at front housingRoller Pin Removal Tool (PN 2872608) disassembly or potential damage to the driveshaft jointsS Over-angling of joints beyond their capacity could result in boot or joint damageS Make sure surface-ground areas and splines of shaft are protected during handling to avoid damageS Do not allow boots to come into contact with sharp edges or hot engine and exhaust componentsS The driveshaft is not to be used as lever arm to position other suspension componentsS Never use hammer or sharp tools to remove or to install boot clampsS Be sure joints are thoroughly clean and that the proper amount and type of grease is used to refill when joint boots are replaced and when joints are cleanedRefer to text for grease capacity of CV joints and CV joint boots
11Remove the spindle and axle assembly from the strut casting bearing by pulling the strut outward as shownDrive out the old seal, taking care not to damage the tapered roller bearingInstall the new seal until it bottoms against the shoulder in the strut casting