2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 88Get this manual
BEARING INSTALLATION
NOTE: To ease bearing installation, warm the crankcase until hot to the touchPlace the bearings in freezer1Install the bearings so the numbers are visible2Drive or press new bearings into the crankcases, using the proper driverCAUTION: Press only on outer race of bearing to prevent bearing damageS 70 mm (2.755driver- For crankshaft main bearingsS 46 mm (1.810For counter balancer bearingsS 28 mm (1.100For pump shaft bearing
END PLAY INSPECTIONADJUSTMENT
Before reassembling the crankcase,the following steps should be performed to determine the amount of crankshaft, counter balancer shaft, and pump shaft end playExcessive end play may cause engine noise at idle and slow speedsToo little play will side load the bearings which may lead to premature bearing failure