2009 Polaris Outlaw 450/525 Service Manual, Page 162Get this manual

2009 Polaris Outlaw 450/525 Service Manual, Page 162

ELECTRICAL Headlight Adjustment
The headlight beam can be adjusted to varied positions by using the following procedures: 1Place the vehicle on level surface with the headlight approximately 25 ft(7.6 m) from wall25 ft(7.6 m) Lamp Center Height in(5.1 cm)

Headlamp Switch Test
Probe the headlamp plug wires at the back of the 3-wire connectorTurn headlight onTest for battery voltage across the connections Low BeamBrown and Green High BeamBrown and Yellow If no voltage is found, test for bad connections, switches, or broken wiringRefer to wire diagram for harness connections
TaillightBrakelight Lamp Replacement
If the taillightbrakelight does not work, disconnect the wire harness and try applying 12 Vdc and known good ground directly to the LED lamp connector as shown belowNOTE: Vehicle shown is for general representation