2009 Polaris Outlaw 450/525 Service Manual, Page 130Get this manual
BODYSTEERINGSUSPENSION 16Discard the excess oil that remains above the IFP17Lube and install the new body cap O-ringApply Green Loctite 638 to the first two threads of the shock bodyThread the body cap onto the body and hand tighten20Using 38" wrench, torque the bearing cap to specification
18Clamp the body in the vise using the body clampsTry to find the location on the body where the IFP is located for higher clamping resistanceDo not over tightenIMPORTANT: Too much damage the body tubeclamping force could Bearing Cap: 30 ftlbs(41 Nm) 21Fill the shock reservoir with nitrogen to 200 PSI by inserting the safety needle squarely into the center of the FOXTM air valve