2009 Polaris Outlaw 450/525 Service Manual, Page 92Get this manual
BODYSTEERINGSUSPENSION 11Press bearing into place until outer race bottoms on housing
UpperLower Control Arm Bolt Torque: 33 ftlbs(45 Nm)
6789Pull drive shaft outward and install hub onto driveshaft splinesInstall cone washer domed side facing outwardInstall retainer nut, wheel and wheel nutsRemove jackstand and torque hub nut and wheel nuts to specification
90 ftlbs(122 Nm) Use an arbor press and only press on the outer race of the bearingFailure to do so, will result in bearing damage12Install snap ring into groove
Carrier Installation
12Insert bearing carrier on drive shaftAlign bottom of carrier housing and lower control armGrease and slide lower control arm bushings into place, securing corner housingInstall both lower control arm boltsLift bearing carrier until top aligns with upper control armInstall and torque upper control arm bolt and torque to specificationTorque lower control arm bolts to specification