2009 Polaris Outlaw 450/525 Service Manual, Page 87Get this manual
BODYSTEERINGSUSPENSION 9To disassemble the inner CV joint, place the CV end on vise and use punch to tap the driveshaft out11To reassemble the inner CV joint, use special Hi Temp CV joint grease to allow the rollers to "stick" to the cageInsert the rollers into the outer cage, then insert the inner joint sideways 180 degrees into the cage assembly and turn the inner joint to capture the rollersThe chamfered end should be facing toward the drive shaft12Using soft faced hammer, tap the drive shaft into the chamfered end of the inner CV assembly until it locks in placeLubricate the inner CV assembly liberally with joint grease before housing reassembly13Before pressing the brake and sprocket hubs apart, remove the sprocket hub snap ring