2009-2010 Polaris RZR Factory Service Manual, Page 257Get this manual
FINAL DRIVE 12Install NEW circlip on the end of the shaft13Grease the joint with the special joint grease provided in the boot replacement kitFill the cavity behind the balls and the splined hole in the joint's inner racePack the ball tracks and outer face flush with greasePlace any remaining grease into the boot18Remove excess grease from the plunging joint's external surfaces and place the excess grease in the boot19Pull the boot over the joint and position the boot lips into the grooves on the joint housing and shaftMake sure the boot is not dimpled or collapsed20Install and tighten the small clamp using the Axle Boot Clamp Tool (PU-48951)
CAUTION
NOTE: The amount of grease that's provided is premeasured, so use all the grease
Boot Replacement Grease Requirement: Grease Only Service Kits
PN 1350059 (20g)PN 1350046 (30g)PN 1350047 (50g)