2009-2010 Polaris RZR Factory Service Manual, Page 198Get this manual
CLUTCHING 8Remove driven clutch offset spacers from the transmission input shaft
Assembly
123Inspect inner clutch cover-to-engine sealReplace if cracked or damagedPlace new foam seal on transmission input shaftApply RTV silicone sealant to outside edge of inner clutch cover-to-engine seal, to ensure water tight fit between the seal and the coverSurfaces must be clean to ensure adhesion of silicone sealantInstall the Drive Clutch Holder (PN 9314177) (A)
10Remove drive clutch retaining bolt and remove drive clutch using the Drive Clutch Puller (PA-48595) (B)