2009-2010 Polaris RZR Factory Service Manual, Page 175Get this manual
BODYSTEERINGSUSPENSION Installation
1Place the A-arm in the correct position for ball joint installationFace the A-arm end flat on top of the driverCarefully drive the ball joint into place until the ball joint is properly seated
FRONT STABILIZER BAR (RZRRZR INT'L)
Sway Bar Linkage Removal
12Elevate and safely support the front of the vehicleRemove the lower shock mounting fasteners and spacers from both upper A-arms on each side of the vehicle (see "Exploded View" on page 5.24)Remove the bolts that attach the upper portion of the linkages to the sway bar clamps and remove the linkages from the vehicle (see "Exploded View" on page 5.24)Inspect the linkage assemblies for signs of excessive wear or damageReplace linkage assembly if damagedReverse the procedure for installationTorque the linkage fasteners to 27-33 ftlbs(37-45 Nm)45Upper A-arm Shown 2After the new ball joint is installed into the A-arm, install NEW retaining ring