2009-2010 Polaris RZR Factory Service Manual, Page 145Get this manual
ELECTRONIC FUEL INJECTION Digital WrenchTMDiagnostic Connector
The diagnostic connector is located under the dash and is accessible from the passenger side
Digital WrenchTM Version and Update ID
Knowing what Digital WrenchTM version and update is installed will help determine which updates are requiredNOTE: Versions and updates are subject to change1Open the Digital WrenchTM softwareLocate the version ID shown on the lower right side of the Digital WrenchTM start-up screenFollow these steps to connect the diagnostic interface cable to the vehicle to allow Digital WrenchTM use: 1234Assemble the SmartLink Module and attach the PC Interface Cable to your laptop (see page 4.3)Remove the protective cap from the Digital WrenchTM connectorConnect the Vehicle Interface Cable to the Digital WrenchTM diagnostic connectorTurn the ignition key to the ON' position, select the appropriate vehicle and wait for the status to display Connected' in the lower left corner of the screenOnce connected, proceed with using Digital WrenchTM2In this case, the version number is 3.1 with 031309 updateProceed to http:polaris.diagsys.com to see if newer update is availableDigital WrenchTM Serial Number Location