2009-2010 Polaris RZR Factory Service Manual, Page 103Get this manual
ENGINE 28Before installing the gearstator housing, replace the seals in the coverInstall new water pump seal (N) into the gearstator housingUse the Water Pump Mechanical Seal Installer (PA-44995) to properly install the seal to the correct depth in the coverNOTE: Install the crankshaft seal (P) with the seal lip facing out (towards the crankcase)
PA-44995
30Once the crankshaft seal is installed into the gearstator housing cover, set the direction of the paper lip by sliding the Main Crankshaft Seal Saver (PA-45658) into the crankshaft seal from the rubber lipped side to the paper lip side (Back to Front)Remove the tool