2008 Polaris Sportsman 700/800/700 X2 EFI Service Manual, Page 355Get this manual
ELECTRICAL Battery Load Test CAUTION
To prevent shock or component damage, remove spark plug high tension leads and connect securely to engine ground before proceedingNOTE: This test can only be performed on machines with electric startersThis test cannot be performed with an engine or starting system that is not working properlyA battery may indicate full charge condition in the OCV test and the specific gravity test, but still may not have the storage capacity necessary to properly function in the electrical systemFor this reason, battery capacity or load test should be conducted whenever poor battery performance is encounteredTo perform this test, hook multitester to the battery in the same manner as was done in the OCV testThe reading should be 12.6 volts or greaterEngage the starter and observe the battery voltage while cranking the engineContinue the test for 15 secondsDuring cranking the observed voltage should not drop below 9.5 voltsIf the beginning voltage is 12.6 volts or higher and the cranking voltage drops below 9.5 volts during the test, replace the batteryNOTE: Recharge to full capacity every 30 to 60 days during non-use periodIf the battery is stored during the winter months, electrolyte will freeze at higher temperatures as the battery dischargesThe chart below indicates freezing points by specific gravity