2008 Polaris Sportsman 700/800/700 X2 EFI Service Manual, Page 235Get this manual
FINAL DRIVE Inboard Joint50g if boot is replaced onlyAnother 50g (100 total) if joint is cleanedcotter pin and hub cap
INSTALLATION
1Slide shaft assembly into bearing carrier hub67
Rear Hub Nut Torque: 80 ftlbs(109 Nm) Install brake caliper and tighten bolts to specificationRefer to Chapter 9Install rear wheel and torque wheel nuts to specification80 ft.lbs(109 Nm)
Apply anti-seize compound to splines of shaftInstall new lock ring and install the shaftLift bearing carrier into place and install bolt to upper control armTorque bolt to specification