2008 Polaris Sportsman 700/800/700 X2 EFI Service Manual, Page 104Get this manual

2008 Polaris Sportsman 700/800/700 X2 EFI Service Manual, Page 104

ENGINE 37Install water pump impeller (P)Secure the impeller with the washer and new nylok nut (Q)Torque the nut to specification39Sparingly apply Starter Drive Grease (PN 2871423) to the starter driveInstall the starter bendixNOTE: There are thrust washers on both sides of starter drive
Water Pump Impeller Nut Torque: 108 inlbs(6.8 0.68 Nm) 38Install water pump cover (R) with new O-ring sealTorque bolts to specification in proper sequence (See front of this chapter)
40Install stator assembly (S) and boltsTorque bolts to specification41Install the wire hold down bracket (T)Install two new wire hold down boltsNew bolts contain patch-lockTorque bolts to specification, following the proper bolt torque sequenceCoat the stator wire grommet (U) with Nyogel Grease (PN 2871329)NOTE: Verify stator wires are routed properly under the wire hold down bracket