2008 Polaris Sportsman 500 EFI/X2/Touring/500 H.O. Service Manual, Page 113Get this manual

2008 Polaris Sportsman 500 EFI/X2/Touring/500 H.O. Service Manual, Page 113

ENGINE TROUBLESHOOTING
Spark Plug Fouling
Spark plug cap loose or faulty Choke cable adjustment or plungercable sticking Foreign material on choke plunger seat or plunger Incorrect spark plug heat range or gap Carburetor inlet needle and seat worn Jet needle andor needle jet worn or improperly adjusted Excessive carburetor vibration (loose or missing needle jet locating pins) Loose jets in carburetor or calibration incorrect for altitudetemperature Incorrect float level setting PVT system calibrated incorrectly or components worn or mis-adjusted Fuel quality poor (old) or octane too high Low compression Restricted exhaust Weak ignition (loose coil ground, faulty coil, stator, or ETC switch) ETC switch mis-adjusted Restricted air filter (main or pre-cleaner) or breather system Improperly assembled air intake system Restricted engine breather system Oil contaminated with fuel Restricted oil tank vent Engine Does Not Turn Over Dead battery Starter motor does not turn Engine seized, rusted, or mechanical failure Engine Runs But Will Not Idle Restricted carburetor pilot system Carburetor misadjusted Choke not adjusted properly Low compression Crankcase breather restricted Engine Idles But Will Not Rev Up Spark plug fouledweak spark Broken throttle cable Obstruction in air intake Air box removed (reinstall all intake components) Incorrect or restricted carburetor jetting ETC switch limiting speed Reverse speed limiter limiting speed Carburetor damaged vacuum slide stickingdiaphragm