2008 Polaris Sportsman 500 EFI/X2/Touring/500 H.O. Service Manual, Page 41Get this manual
MAINTENANCE Engine Oil Level Oil and Filter Change
Oil Filter Torque: Turn by hand until filter gasket contacts sealing surface, then turn an additional 12 turn Oil Filter Wrench: (PV-43527) Oil Tank Screen Fitting Torque: 25 ft-lb (34Nm)
Recommended Engine Oil: Polaris Premium All Season Synthetic, 2W-50
The oil tank is located on the left side of the vehicleTo check the oil level: 12345Set machine on level surfaceClean the area around the dip stickStart and run engine for 20-30 secondsThis will return oil to its true level in the oil tankStop engine, remove dipstick (A) and wipe dry with clean clothReinstall dipstick, screw the dipstick into place
WARNING
Personal injury can occur when handling used oilHot oil can cause burns or skin damageNOTICE: Care must be taken to ensure that the fluids are containedBe prepared to collect the fluid with suitable containers before opening any compartment or disassembly of any component containing fluids12345Place vehicle on level surfaceClean area around drain plug (A) at bottom of oil tankRun engine two to three minutes until the engine is warmAfter two or three minutes stop the enginePlace drain pan beneath oil tank and remove the drain plug (A)CAUTION: Oil may be hotDo not allow hot oil to come into contact with skin as serious burns may result