2008 Polaris Ranger RZR Service Manual, Page 226Get this manual
FINAL DRIVE 4Lift bearing carrier into place and install the bolt attaching the bearing carrier to the upper A-armTorque fastener to 37 ftlbs(50 Nm)
Rear Caliper Mounting Bolt Torque: 18 ftlbs(24 Nm)
CAUTION
37 ftlbs50 (Nm) New bolts have pre-applied locking agent which is destroyed upon removalAlways use new brake caliper mounting bolts upon assembly8Torque wheel hub nut to 80 ftlbs(108 Nm) and install NEW cotter pinTighten nut slightly if necessary to align cotter pin holes
Rear Bearing Carrier Bolt Torque: 37 ftlbs(50 Nm) 56Apply grease to drive shaft axle splinesInstall rear wheel hub assembly, cone washers, and hand tighten the castle nutInstall washers with domed side out80 ftlbs(108 Nm)