2008 Polaris Ranger RZR Service Manual, Page 224Get this manual
FINAL DRIVE IMPORTANT: If the grease in the joint is obviously contaminated with water andor dirt, the joint should be replaced7Thoroughly clean the joint with an appropriate solvent and dry the joint to prevent any residual solvent from being left in the joint upon reassemblyVisually inspect the joint for damageReplace if neededSlide the boot clamp and boot (small end first) onto the drive shaft and position the boot in its groove machined in the shaft12Grease the inner and outer joint racesFully compress the joint and push the drive shaft firmly into the inner race13Align the circlip with the lead-in chamferShown without grease for clarity
10Install NEW circlip on the end of the shaft
14Use soft-faced hammer to assemble the shaft into the inner race until you reach the end of the splines