2008 Polaris Ranger RZR Service Manual, Page 219Get this manual
FINAL DRIVE Bearing Carrier Installation
1Install drive shaft axle through the backside of the bearing carrierBe sure bushings and pivot tubes are installed5Install brake caliper mounting bolts and torque to 18 ftlbs(24 Nm)
18 ftlbs24 (Nm)
2Install the fasteners that attach the rear bearing carrier to the upper and lower A-armsTorque bolts to 37 ftlbs(50 Nm)Rear Caliper Mounting Bolt Torque: 18 ftlbs(24 Nm)
CAUTION
New bolts have pre-applied locking agent which is destroyed upon removalAlways use new brake caliper mounting bolts upon assembly6Torque wheel hub nut to 80 ftlbs(108 Nm) and install NEW cotter pinTighten nut slightly if necessary to align cotter pin holes