2008 Polaris Ranger RZR Service Manual, Page 174Get this manual
CLUTCHING 8Remove driven clutch offset spacers from the transmission input shaftKeep Spacers In Order (Note Thickness) 23
Assembly
1Inspect inner clutch cover-to-engine sealReplace if cracked or damagedPlace new foam seal on transmission input shaftApply RTV silicone sealant to outside edge of inner clutch cover-to-engine seal, to ensure water tight fit between the seal and the coverSurfaces must be clean to ensure adhesion of silicone sealantApply RTV Silicone Here
Retaining Bolt
Install the Drive Clutch Holder (PN 9314177) (A)