2008 Polaris Ranger RZR Service Manual, Page 121Get this manual
ELECTRONIC FUEL INJECTION 8Lift the mounting bracket straight up and out from the vehicleRemove Bracket Installation IMPORTANT: When reinstalling the transmission to rear gearcase mount bracket, it is extremely important to torque all (7) fasteners to specificationRefer to the following procedureNOTE: Special tool (PA-48873) will be required to torque the mounting bracket fasteners when the transmission and rear gearcase are installed in the vehicleSpecial Tool PA-48873
9Using mm hex wrench, remove the CPS retaining bolt and remove the sensor from the magneto housing
10Install new sensor using light coating of oil on the o-ring to aid installation11Torque the CPS retaining bolt to specification
CPS Retaining Bolt Torque: 25 inlbs(2.8 Nm) 1