2008 Polaris Ranger RZR Service Manual, Page 99Get this manual
ENGINE FlywheelStator Installation
NOTE: Before assembly, clean the bolts and bolt holes with Primer (PN 2870585) to remove any debrisThis will ensure proper sealing when installing bolts12Install stator assembly (S) and boltsTorque bolts to specificationInstall the wire hold down bracket (T)Install two new wire hold down boltsNew bolts contain patch-lockTorque bolts to specification, following the proper bolt torque sequenceCoat the stator wire grommet (U) with NyogelTM Grease (PN 2871329)4
Flywheel Nut Torque 65 ft.lbs(88 9.50 Nm) Install stator housing with new o-ringsTorque the bolts to specification and follow proper bolt torque sequence at the beginning of this chapter