2008 Polaris Ranger RZR Service Manual, Page 62Get this manual
ENGINE 22Loosen the hose clamp between the throttle body and intake adaptorLoosen Clamp 25Remove the airbox and throttle body from the vehicle as an assemblyTake care in not allowing the throttle cable to bend excessively or kinkCarefully place the assembly on the floor next to the vehicleInsert shop towel into the engine intake adaptor to prevent dirt from entering the engineNOTE: Ensure throttle cable is not being excessively bent or kinked while removed from the vehicle26Mark the fuel injector harnesses to identify MAG and PTO harness connections to aid during reassemblyDisconnect the fuel injector harnessesNOTE: The Bosch harness connector and locking spring is bonded to the fuel injectors with an epoxy mixDO NOT attempt to disconnect the Bosch connector from the fuel injectorsDamage will occur to the injector andor harness if attempting to separate at that locationSeparate the fuel injector from the vehicle by disconnecting at the end of the harness as shownFuel Injector Disconnect Here Harness